This output is used with the application also known as the "Motion
Monitor Display." It uses input from a CameraInput
library component and displays output via the OrbOutput library
component.
Starts this Input with the IP address AudioConstants.DEFAULT_INPUT_IP and
sets the time between events to AudioConstants.DEFAULT_AUDIO_TIME_BETWEEN_EVENTS.
Starts this Input with the IP address PTKConstants.DEFAULT_INPUT_IP
Can instead take one command line parameter: (1) IP address where this
Input is running.
When you want to connect multiple inputs to each of the given outputs, abstractors, and notification
setters, pass an array of InputSource objects into makeConnection.
Use versions of makeConnection that take an array of Metadata objects when you
want to connect multiple inputs to each of the given outputs, abstractors, and
notification setters.
Handles making the connection between the given input and output, via
the abstractors, notification setters, and transitions specified, for
distributed applications.
Handles making the connection between the given input and output, via
the abstractors, notification setters, and transitions specified, for
non-distributed applications.
Returns an event that is somewhere between the start and end points of a
make aware transition, depending on the display_step and the number of
steps involved in the transition.
Set this to customize the number of pixels below which the motion dector
will to set the AMOUNT_OF_MOTION to MOTION_MED and above which the motion
detector will set it to MOTION_HI.
The serial number is assigned on the microprocessor of the connector
circuit board (i.e., the interface kit itself does not have a serial number -
the USB port to USB hub / device board has a serial number.
The serial number is assigned on the microprocessor of the connector
circuit board (i.e., the interface kit itself does not have a serial number -
the USB port to USB hub / device board has a serial number.
The serial number is assigned on the microprocessor of the connector
circuit board (i.e., the LED itself does not have a serial number -
the USB port to USB hub / device board has a serial number.
The serial number is assigned on the microprocessor of the connector
circuit board (i.e., the servo motor itself does not have a serial number -
the USB port to USB hub / device board has a serial number.
myframe -
Static variable in class edu.berkeley.guir.ptk.evaluation.PopUpFrame